Recent content by Matthew Main

  1. Matthew Main

    Call Privacy

    So the dial plan is now working, but the From is not being set correctly. Meaning that a carrier that is pulling the CLI from the FROM is still displaying the number. its currently <sip:host@domain> it should be <sip:anonymous@anonymous.invalid> Does anyone have any ideas?
  2. Matthew Main

    Can I create FusionPBX cluster

    That would go against Mark and his training. The reason he charges for support and training is so that he can continue to develop the project. With no funding, there would be no FusionPBX.
  3. Matthew Main

    Call Privacy

    Good to know! I will make the changes and test
  4. Matthew Main

    Can I create FusionPBX cluster

    Mark teaches how to complete Master-Master replicating and fail over as part of the advanced Fusionpbx course.
  5. Matthew Main

    Call Privacy

    Does not look the call is even touching the dial plan. I have setup a stable branch box to test further.
  6. Matthew Main

    Call Privacy

    I was playing with it, but I did complete the way whut suggested and still no luck.
  7. Matthew Main

    Call Privacy

    Privacy is not being marked in the invite.
  8. Matthew Main

    Call Privacy

    Yeh I set the dial plan as whut as described but its not acting in anyway, still showing outbound / emergency cli
  9. Matthew Main

    Call Privacy

    I figured out how to get the dial plan in, but I can't get it to work, I have reloaded XML, but it's not picking it up.
  10. Matthew Main

    Call Privacy

    No option to add the conditions on my version of Fusion 5.1.0 RC1
  11. Matthew Main

    Call Privacy

    This did not work.
  12. Matthew Main

    Call Privacy

    Hey all, I am either being an idiot or not seeing the option, I have a number of exts that are required to call out anonymously, now I know the *67 works but want to know if there is a way to turn on call privacy for each ext individually for every call. Found a few guides to mod the default...
  13. Matthew Main

    FusionPBX outgoing call failed

    As you are IP authenticating has your carrier whitelisted your IP? im basing this on the 407 Proxy Auth error seen in the SIP trace I have my ACL setup the same way you did , IP address that the provider will be sending calls from in CIDR with the correct subnet mask.
  14. Matthew Main

    FusionPBX outgoing call failed

    How is your gateway setup up? Who is your provider? also how is your extension setup? what have you setup for outbound routes? When you changed the ACL did you flush cache and reload xml?
  15. Matthew Main

    Adding Yealink T27G firmware

    Im going to to write a how to, if Mark gives me the thumbs up I will post it publicly. I dont want to rock any boats