Recent content by Kwekkel

Hi, When originating a fax call from fs_cli a "require timer" line is included. Would it be possible to get rid of it? originate {origination_caller_id_number=+49xxxx,fax_verbose=true,absolute_codec_string='PCMA'}sofia/gateway/372ea7c3-8ffa-4df1-8d33-dde662xxxxx/+31xxxxxxx...

Hi Steve, Yes, changed /etc/hots. Finally I decided to just start with a new setup. Our implementation is not that big so copying over the data "manually" was doable. Regards.

Hi, The idea was to install a new instance of Fusionpbx on a new server and restore a database backup from the old server and then swap ip adddresses in both server interface configuration. Old server ip 192.168.1.233 New server ip 192.168.1.236 For some reason Freeswich still wants to bind to...

Hi. I would like to enable SCTP support. Does Fusionpbx support SCTP? Did quite some searching but got stuck. I've found this so far: install libsctp-dev. That is the easy part. Then I need to enable SCTP in Fusionpbx. Where to enable? Thanks in advance.

Hello, I am wondering if it would be possible to fall back to PCMA on reception of a 488 as answer on a t38 re-invite. Fusion ------> invite PCMA <------- 200 ok -------> T38 re-invite <------- 488 not acceptable here Call drops after 60 seconds and fax...

Please look here: https://freeswitch.org/confluence/display/FREESWITCH/Channel+Variables Hope it helps.

Set t38-passthru to true fixed the problem. How could i have missed this... Thanks for helping me out.

Hi, I send an outbound fax call and after call establishment the remote party sends a T38 re-invite. The response is 488 Not acceptable here. Any ideas/suggestions? Thanks.

Hi Acoma, Can you please share what you have changed in the config.sh? Thanks