INBOUND CALLS NOT WORKING

Status
Not open for further replies.

ruben23

New Member
Jun 6, 2019
6
0
1
43
Guys i have registered successfully my VoIP trunk on the Gateway of my Fusion PBX its status is registered and also registered on the End point of the VoIP carrier
but still when we dial the number DID inbound it wont connect
i also added already the 10 Digit DID# on the destination and generated an inbound routes from it

Then next i added the VoIP carrier gatewayIP and media IP on the ACL including whitelisting it on the IPtables, still call got rejected and get this logs from the console

https://pastebin.com/2vJvFG4T

any help guys.?
 

mingus

Member
Mar 23, 2018
43
7
8
53
FusionPBX has it's own ACLs. The log entry,

2019-06-14 20:21:10.147973 [WARNING] sofia.c:10037 IP 192.76.120.10 Rejected by acl "domains"​
shows that the IP address delivering the inbound call is being rejected.

In FusionPBX, go to Advanced/Access Control. Then select the "domains". Add a new "node" with the following settings:

TYPE: Allow​
CIDR: 192.76.120.10/32​
DESCRIPTION: Telnyx​
Press Save. Enjoy.
 

ruben23

New Member
Jun 6, 2019
6
0
1
43
Thanks a lot it working now finally after hours of troubleshooting, now my problem again is outbound when trying to dial it drops right away
i used the same gateway where my inbound routes is setup and work\king

EXECUTE sofia/internal/800@pbx.sas2.co log([inbound routes] 404 not found 49.151.227.207)
2019-06-15 00:26:41.059858 [DEBUG] mod_dptools.c:1742 routes] 404 not found 49.151.227.207

https://pastebin.com/RjPWp6mU
 
Status
Not open for further replies.