Recent content by Starburst

Are there any recommended Voice AI agents for FS PBX for like the initial IVR, so it just can be talked to instead of sounding like the dated IVR, Press 1 for..., Pres 2 for..?

Looked again, don't see any REGEX being setup when the Gateway, or DID is added. :confused:

That's what I got (just changed the number), but sip_req_user didn't work either:

Tried that, got the same 404: :(

Attached is the fs cli log when I tried an incoming call. (Times are in Zulu/UTC/GMT) Obviously I replaced MYCELL, CallCentric-1777, and CallCentric-DID for some security. Sometimes with CallCentric, depending on the equipment you have to enter 1777xxxxxxxEXT, which I tried both ways. Also...

FS PBX Version: 2.0.1 FreeSWITCH Version: 1.11.3 Trying to add CallCentric. Both FS PBX and CallCentric show they are connected. But when a test call is made in, FS PBX responds with: WARNING [inbound routes] 404 not found Both the destination_number and sip_to_user have entries in Inbound...

From what I could find, it has said to report them here I think I found a bug with FS PBX and a certain block of phone numbers. Most phone numbers show up as (123) 456-7890 But, I have a block that just show up as 1234567890 All seems to work, and seems just like a display issue.

TLS is fixed. Found a similar discussion in the FusionPBX forum. Did the following, and batta bing, batta boom, TLS started working: chown -R www-data:www-data /etc/freeswitch/tls

I followed https://www.fspbx.com/docs/configuration/tls-certificates/lets-encrypt/ After enabling TLS, and telling the phones to use TCP/TLS Port 5061, both phones won't connect. The Poly B10 is showing: Register Failed: No Response From Server (server=1.2.3.4:5061; retry in 20s) Changed IP...

Tried again tonight. Getting the same screens. Get the 407 Proxy Authentication request, phone sends ACK & INVITE back. But then the phone doesn't see any reply from the PBX. After 7 INVITES, the phone gives up and displays "Call failed. Request timed out." And then it shows the 481 error...

Which is odd. PBX is in the cloud. I can connect from my location fine with MicroSIP, Grandstream & Poly phones. They can connect with MicroSIP normally using the SIP Credentials and dialing in/out works. But the Poly B10 connects and can receive inbound calls, but can't make any outbound...

Phone just showing it's trying to call the other extension, and no error message on phone. Have a screenshot from sngrep. This is edited, so not to disclosed IP's. Tried MicroSIP, and all works OK. It looks to point to the phones DigitMap config somewhere.

Tried that at the start of the week. It also gave me: xxxx|xxxxx|911|9[2-9]11|*xx|*xxx|9[2-9]xxxxxxxxx|91[2-9]xxxxxxxxx|9011xxx.T To give internal extensions priority. Even tried the one from VoIP.ms Wiki for the B10 on their system...

Still having the problem where that extension can register to the PBX, receive calls from an extension, and also an external phone number that points directly. That extension however can't dial an internal extension or external number. I know it's in the DigitMap somewhere. Does anyone have a...

If I enable TLS on FS PBX can phones still connect without it, or is it an all or nothing? Thanks