I am currently migrating a small installation (30 DID, 5 tenants) from another PBX to FusionPBX, which I've used in the past and found very powerful as compared to other open source PBX's such as FreePBX and the like. I also like the FreeSWITCH platform much better than Asterisk.
I installed and started to configure FusionPBX before learning about FS PBX. Is it currently possible to install the current FS PBX with the latest FusionPBX already in place?
I quickly looked at the YouTube videos for the FS PBX project and see there are two videos about installation - one seems to guide you through FusionPBX install and then FS PBX, and the other is the newer, single command (integrated) install.
If it is possible, then if I were to install FS PBX on top of FusionPBX, should I follow along with the "old/outdated" video (since it seems to break up the FusionPBX and FS PBX install), or should I take the current single command installer and comment out the FusionPBX install bits? Or something else?
If possible, I'd like to have FusionPBX 5.3, which I understand is not the forked version currently used by FS PBX. Are there any breaking changes between the fork and FusionPBX master? I've read (I think on Reddit) that it should work, but since both projects are under active development, I wanted to see if this was still the case.
Thanks for any advice or assistance you can provide.
I installed and started to configure FusionPBX before learning about FS PBX. Is it currently possible to install the current FS PBX with the latest FusionPBX already in place?
I quickly looked at the YouTube videos for the FS PBX project and see there are two videos about installation - one seems to guide you through FusionPBX install and then FS PBX, and the other is the newer, single command (integrated) install.
If it is possible, then if I were to install FS PBX on top of FusionPBX, should I follow along with the "old/outdated" video (since it seems to break up the FusionPBX and FS PBX install), or should I take the current single command installer and comment out the FusionPBX install bits? Or something else?
If possible, I'd like to have FusionPBX 5.3, which I understand is not the forked version currently used by FS PBX. Are there any breaking changes between the fork and FusionPBX master? I've read (I think on Reddit) that it should work, but since both projects are under active development, I wanted to see if this was still the case.
Thanks for any advice or assistance you can provide.