HI Guys
I have been using fusionpbx for a few weeks, I have found my way to set it up mostly by searching these forums, so thanks for that guys.
I have also played with FreeSWITCH a bit as well and managed to get some parts working.
What I am not sure about is how fusionpbx implements it's GUI, I looked at the code on Git and see a lot of use of SQL, I am guessing then
that XML files are not read and written to but rather the dialplan and routes are all stored in SQL, if so how are they loaded?
I am trying to create a very basic GUI on FreeSWITCH with can create extensions, setup gateways, and load and listen to recordings.
I would appreciate being nudged in the right direction.
thanks
K
I have been using fusionpbx for a few weeks, I have found my way to set it up mostly by searching these forums, so thanks for that guys.
I have also played with FreeSWITCH a bit as well and managed to get some parts working.
What I am not sure about is how fusionpbx implements it's GUI, I looked at the code on Git and see a lot of use of SQL, I am guessing then
that XML files are not read and written to but rather the dialplan and routes are all stored in SQL, if so how are they loaded?
I am trying to create a very basic GUI on FreeSWITCH with can create extensions, setup gateways, and load and listen to recordings.
I would appreciate being nudged in the right direction.
thanks
K