Recent content by btil

The IP of the Pi has never changed following a reboot, has always been 192.168.4.49 After running cd /usr/src/fusionpbx-install.sh/debian && ./install.sh again and waiting 5 minutes for the program to revisit its past. Only one of my two 2160's is now registered. The other has two "Extensions"...

mat1010, I thank you for your assistance. I've got to run. I'll work at this later this eve if time permits. Thanks again!

root@raspberrypi:/var/log/freeswitch# tail -f freeswitch.log 2020-09-11 06:28:16.899912 [NOTICE] switch_utils.c:658 Adding 127.0.0.0/8 (allow) [] to list loopback.auto 2020-09-11 06:28:16.899912 [NOTICE] switch_utils.c:658 Adding ::1/128 (allow) [] to list loopback.auto 2020-09-11...

Thank you for that correction mat1010. status nginx returned Loaded: loaded (/lib/systemd/system/nginx.service; enabled; vendor preset: enabled) Active: active (running) since Thu 2020-09-10 22:25:33 EDT; 16h ago Docs: man:nginx(8) Process: 486 ExecStartPre=/usr/sbin/nginx -t -q -g...

I did a shutdown of the Pi to try to repeat the issue. The fusionPBX page did come back and I can log in, however my two phones, I'm testing with, have lost registration. Trying the strings referenced by "agree" and "mat1010" return the following: root@raspberrypi:~# systemct1 status...

Thank you Adrian, That worked nicely.............only twice needed!

When I type the Pi IP address into the browser the page was not found. Timed out.

FYI, Tried to minimize on chrome and firefox no change. If I move the task bar to the side can get a few more lines. But never see "Voicemail" Worked okay on my LG tablet.

I guess the question is, after a shutdown (either intentional or a power loss) once the Pi reboots what action(s) are required to restart FusionPBX? The IP remained the same. The GUI login did not load. What other info would you like to see? Thank you.

Thank you for your reply and question. I shutdown the Pi to relocate. When booted back up I could not open the PBX Gui. I had to perform the Install string to get the PBX working again. I'm concerned if I place this in a commerical application and there is a loss of power the system will not...

On my PC, when logged into FusionPBX and I hover over the Applications Tab, The cloumn fills to the bottom on the screen (task bar). "Recordings" is the last oprion there. I cannot get to or see any choice below that. What trick am I missing?

When I shutdown my Pi to relocate the FusionPBX did not restart on Pi boot. Why did FusionPBX not load on boot? What is the command to restart FusionPBX without going to /usr/src/fushion-install.sh/debian/ && ./install.sh ?

Just loaded FusionPBX on a PI 4 and like to use the GXP2160 for the 24 button BLF panel. Have tried programming a Call Park and Monitored Call Park button on the physical buttons using *5901. The park togles and works fine either way....however the Park never lights and the Monitored stays...