Hey Folks,
So I am new to FusionPBX, coming from Sydney, Australia, I have just setup my first copy of it and have watched the basic videos on how to setup a gateway and an extension. Created and inbound route and I am just trying to test incoming calls. What I am getting however is the call starts to dial on my phone I see it reach the PBX but it never rings on either the dialing phone or the extension and after about 5 - 10 seconds it ends the call and I can't seem to see why, I enabled the logs which are attached with just the mobile number redacted.
Is someone able to possibly assist, not sure if it perhaps a country code I need to change or something. I am genuinely unsure where to look next.
Thanks, Josh.
So I am new to FusionPBX, coming from Sydney, Australia, I have just setup my first copy of it and have watched the basic videos on how to setup a gateway and an extension. Created and inbound route and I am just trying to test incoming calls. What I am getting however is the call starts to dial on my phone I see it reach the PBX but it never rings on either the dialing phone or the extension and after about 5 - 10 seconds it ends the call and I can't seem to see why, I enabled the logs which are attached with just the mobile number redacted.
Is someone able to possibly assist, not sure if it perhaps a country code I need to change or something. I am genuinely unsure where to look next.
Thanks, Josh.